Gym Weight Stack Plate Rubber Spacer fitted between the Weight Plates on Strength Equipment to evenly space them and enable easier insertion of the Selector Pin
After a period of time and constant slamming down of the Weight Plates you can sometimes encounter compression between the plates resulting in the Weight Plate holes becoming misaligned with the holes in the Centre Pin making it hard or impossible to insert the Selector Pin
Remedy: Counting downwards to the problem Plate that will not select, place the Selector Pin into the Plate immediately above the problem plate, then raise the selected weight stack and hold in position while an accomplice, using a sharp knife, slices open two Rubber Washers and places them around each of the Guide Bars (either side the Centre Pin) so they each sit on the surface of the problem Plate. Once the weight stack is then lowered, the Centre Pin and plates directly above the problem plate will have risen by 2mm in total including the Centre Pin holes and will have effectively lowered the plates from the problem plate downwards allowing easy insertion of the Selector Pin once again
Washer Thickness: 2mm
Inside Hole Diameter: 30mm
Quantity: Pack of 10
Part Number: 10-0010
Availability: In Stock
